Keysight Technologies N9020A Installation Note page 24

Exa/mxa signal analyzer

Hide thumbs Also See for N9020A:

Installation Procedure

Figure 11

RF Front End Assembly Removal

5. Using the T-6 driver, remove the four screws (3) securing the A13A1 bandpass filter (4) to the

A13 Front End Assembly. Discard these screws.

6. Disconnect ribbon cable W17 from A13J12.

7. Disconnect A13W1 (5) and A13W2 (6) from A13 Front End Assembly and remove the

combination of A13W1, A13W2, and A13A1 as a unit. This unit will be used as a guide to

assemble the new A13W1 and A13W2 to the new A13A1.

8. Refer to

Figure

12. Locate the spacer, E6607-25005, in the kit. Install the spacer (1) where the

old A13A1 bandpass filter was located. Secure with four 0515-0658 screws (2) and torque to

3 inch-pounds using the T-6 driver.

Installation Note N9010-90054

Table of Contents

N9010a