Keysight Technologies N9020A Installation Note page 31

Exa/mxa signal analyzer

Hide thumbs Also See for N9020A:

Installing Microwave Preselector Bypass Switches

1. Refer to

Figure

18. Remove the ribbon cable W18.

Figure 18

Low Band Switch Removal

2. Remove the semi-rigid cables W3, W8, W9, and W10 using the 5/16 inch wrench. These

cables will not be used when the Low Band Switch is re-installed.

3. Remove the two screws (2) using the T-10 driver. The low band switch (1) can now be

removed from the chassis.

Installation Note N9010-90054

Installation Procedure

Table of Contents

N9010a