Keysight Technologies N9020A Installation Note page 30

Exa/mxa signal analyzer

Hide thumbs Also See for N9020A:

Installation Procedure

3. Refer to

Figure

17. Install the Enhanced Front End Control assembly included in this kit into

slot 6 in the chassis securing with the ejector.

4. Reattach the ribbon cables W16, W17, and W18 to the Front End Control assembly (1).

5. If the analyzer does not have Option 503, replace the existing W22 wire harness with the new

W22 (N9020-60059) included in the kit. Connect W22 between J300 on the Front End Control

and the A12 YTF Preselector.

Figure 17

Enhanced Front End Control Assembly Installation

Installation Note N9010-90054

Table of Contents

N9010a