Enabling Or Disabling The Poll Timer; Shutting Down The System - Siemens SCALANCE WLC711 Maintenance Manual

Enabling or Disabling the Poll Timer

To Enable or Disable the Poll Timer:
1 From the top menu, click Wireless Controller.
The Wireless Controller Configuration screen is displayed.
2 From the left pane, click Administration > System Maintenance.
3 Do one of the following:
•
To disable the poll timer, select the Disable Poll Timer checkbox in the Health Checking section.
•
To enable the poll timer, clear the Disable Poll Timer checkbox in the Health Checking section.
4 Click Apply.

Shutting Down the System

An alternative method of stopping the software operation is to use CLI commands. For more
information, see the CLI Reference Guide.
Notice
Do not power off the controller by using the power switch only. Instead, carry out the entire procedure
as described in this section. Failure to do so may corrupt the data on the hard disk drive.Once you have
shut down the system as described in this section, then power off the controller using the power switch
on the controller.
To Shut Down the System:
SCALANCE WLC711 Maintenance Guide
Performing System Maintenance
Enabling or Disabling the Poll Timer
51