Installing A Drive In Bay 2 Or 3 - IBM Aptiva Handbook

Installing a drive in bay 2 or 3

Bay 2 or 3 can hold up to a 5.25-inch half high drive, such as a diskette, tape, hard disk, or CD-ROM drive.
1.
Insert the drive into the bay. Align the screw holes
and insert the four screws.
(Front View)
2.
Connect the power and signal cables to the drive. If
you are installing a CD-ROM drive, also connect
the audio cable from the sound card.
Drive
Power Cable
Signal Cable
Audio Cable
Drive
If you add a diskette drive or tape drive that attaches to the
Diskette connector, make sure the signal cable you plug into
the drive is attached to the Diskette connector on the
Note: system board. If you add a CD-ROM, it is recommended that
you attach the signal cable to Local Bus connector 2 on the
system board. To identify the connectors, see "Identifying
signal cable connectors" on page 86.
(Back View)
Adding and removing drives 91