Installing A Drive In Bay 1 - IBM Aptiva Handbook

Installing a drive in bay 1

Bay 1 can hold a 3.5-inch slim drive, such as a diskette or tape drive.
1.
Insert the drive into the bay. Align the screw holes
and insert the four screws.
(Front View)
90 Chapter 7: Working with adapter cards and drives
2.
Connect the power and signal cables to the drive.
Drive
Signal Cable
Power Cable
Drive
If you add a diskette drive or a tape drive that attaches
to the Diskette connector, make sure the signal cable
you plug into the drive is attached to the Diskette
Note:
connector on the system board. To identify the Diskette
connector on the system board, see "Identifying signal
cable connectors" on page 86.
(Back View)