Installing A Drive In Bay 1 Or Bay 2 - IBM ThinkCentre 8131 User Manual

Installing a drive in bay 1 or bay 2

To install a drive in bay 1 or bay 2, follow these steps:
1. Remove the cover. See "Removing the cover" on page 10.
2. Remove the front bezel by pressing downward on the plastic tabs 1 and
pulling the bezel as shown.
3. Remove the static shield from the drive bay by using a flat-blade screwdriver
to gently pry it loose.
4. Remove the plastic panel in the bezel for bay 1 or 2 by squeezing the plastic
tabs that secure the panel on the inside of the bezel.
5. Make sure the drive that you are installing is set correctly as either a master
or a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
v If it is the first CD drive or DVD drive, set it as a master device.
v If it is an additional CD drive or DVD drive, set it as a slave device.
v If it is an additional parallel ATA hard disk drive, set it as a slave device.
Chapter 1. Installing options
17