LG MASTER-K 120S Series User Manual page 63

Chapter 5 Power Supply / CPU
2) Special data register for forced I/O
The contents of forced I/O setting is registered to special data register as below.
It is possible to use 'forced I/O function' to program.
All Forced I/O enable
Forced I/O enable by bit
Forced I/O set data
3) Force on/ off Processing timing and method
(1) Forced Input
After data have been read from input modules, at the time of input refresh the data of the junctions which
have been set to force on/off will be replaced with force setting data to change the input image area. And
then, the user program will be executed with real input data and force setting data.
(2) Forced output
When a user program has finished its execution the output image area has the operation results. At the time
of output refresh the data of the junctions which have been set to force on/off will be replaced with force se
tting data and the replaced data will be output. However, the force on/off setting does not change the output
image area data while it changes the input image area data.
(3) Precautions
Turning the power off and on, changes of the operation mode or operation by reset switch does not change
the previous force on/off setting data. They remain within the CPU module and operation is executed with
the same data.
Forced I/O data will not be cleared even in the STOP mode.
When setting new data, disable every I/O settings using the setting data clear function and set the new data.
REMARK
-. For detailed operation, refer to the KGLWIN user's Manual Chapter 7 'Force I/O setting.
Items Special Device
M1910
D4700 ~ D4763
D4800 ~ D4863
5-26