Add Application Rule - ZyXEL Communications ZyWALL 1100 User Manual

33.4.1 Add Application Rule

Click Add in Configuration > Object > Application > Application to create a new application
rule. In the first screen you type a name to identify this application object and write an optional
brief description of it.
You then click Add again to choose the signatures that should go into this object.
Figure 364 Configuration > Object > Application > Application > Add Application Rule
The following table describes the labels in this screen.
Table 228 Configuration > Object > Application > Application > Add Application Rule
LABEL
Name
Description
Add
Remove
#
Category
Application
OK
Cancel
Chapter 33 Object
DESCRIPTION
Type a name to identify this application rule. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
You may type some extra information on the application object here.
Click this to create a new application rule.
Click this to remove the selected application rule.
This field is a sequential value associated with this application rule..
This field shows the category to which the signature belongs in this application rule.
This displays the name of the application used in this application rule.
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving your changes.
ZyWALL/USG Series User's Guide
553