Fingerprint Reader Module - HP Spectre x360 Maintenance And Service Manual

Fingerprint reader module

NOTE: The fingerprint reader module spare part kit includes the bracket but does not include the fingerprint
reader module cable. The fingerprint reader module cable is available using spare part number L71957-001.
Table 5-9 Fingerprint reader module description and spare part number information
Description
In natural silver finish
In nightfall black finish
In Poseidon blue finish
Before removing the fingerprint reader module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the speakers (see
Remove the fingerprint reader module:
1. Release the ZIF connector (1) to which the fingerprint reader module cable is connected, and then
disconnect the fingerprint reader module cable from the system board.
2. Detach the fingerprint reader module cable (2) from the top cover. (The fingerprint reader module cable is
attached to the top cover with adhesive.)
3. Remove the two Phillips M2.0×2.7 screws (3) that secure the fingerprint reader module and bracket to
the top cover.
4. Remove the fingerprint reader module bracket (4).
52 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 36).
Speakers on page 48).
34).
Spare part number
L71963-001
L71964-001
L71962-001