Solid-State Drive - HP Spectre x360 Maintenance And Service Manual

Solid-state drive

Table 5-4 Solid-state drive description and spare part number information
Description
2-TB, PCIe, NVMe, solid-state drive with TLC
1-TB, PCIe, NVMe, solid-state drive with TLC
512-GB, PCIe, NVMe, solid-state drive with TLC
256-GB, PCIe, NVMe, solid-state drive with TLC
1-TB, PCIe, NVMe+32-GB 3D XPoint solid-state drive
512-GB, PCIe, NVMe+32-GB 3D XPoint solid-state drive
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the solid-state drive shield (1) from the system board.
The solid-state drive is not available as a spare part.
NOTE:
When installing the shield, special care should be taken to make sure that the shield is correctly installed in
these clips (3).
40 Chapter 5 Removal and replacement procedures
Bottom cover on page
The solid-state drive shield is secured to the system board by a series of metal clips (2).
34).
Battery on page 36).
Spare part number
L71983-001
L71979-001
L71984-001
L71982-001
L71980-001
L71981-001