Fingerprint Reader Module - HP Spectre x360 13 Maintenance And Service Manual

Fingerprint reader module

NOTE: The fingerprint reader module spare part kit includes the fingerprint reader module cable.
Description
In dark ash silver finish
In natural silver finish
In pale rose gold finish
Before removing the fingerprint reader module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the fingerprint reader module:
1. Release the zero insertion force (ZIF) connector (1) to which fingerprint reader module cable is connected,
and then disconnect the fingerprint reader module cable from the system board.
2. Remove the fingerprint reader module (2) from the slot in the keyboard/top cover.
Reverse this procedure to reassemble and install the fingerprint reader module.
34 Chapter 5 Removal and replacement procedures
Bottom cover on page 29).
Battery on page 31).
Spare part number
942839-001
L02693-001
L07433-001