Fingerprint Reader Module - HP Spectre x360 15 Maintenance And Service Manual

Fingerprint reader module

Description
Fingerprint reader module
IMPORTANT:
and replacement
Before removing the fingerprint reader module, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
Battery (see
▲
Remove the fingerprint reader module:
1. Release the fingerprint reader module cable from the ZIF connector on the fingerprint reader board (1).
2. Remove the fingerprint reader module bracket (2).
3. Remove the fingerprint reader module and cable (3).
Reverse this procedure to install the fingerprint reader module.
Make special note of each screw and screw lock size and location during removal
Bottom cover on page
Battery on page
29), and then remove the following components:
31).
Spare part number
L15602-001
Component replacement procedures 35