Infrared Sensor Board Cable - HP Spectre x360 Maintenance And Service Manual

Reverse this procedure to install the infrared sensor board and cable.

Infrared sensor board cable

NOTE: The infrared sensor board cable is available using spare part number L71960-001.
Before removing the infrared sensor board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Display assembly (see
c. System board (see
d. Infrared sensor board (see
Remove the infrared sensor board cable:
▲
Release the ZIF connector (1) to which infrared sensor board cable is connected, and then disconnect
the infrared sensor board cable (2) from the infrared sensor board.
Reverse this procedure to install the infrared sensor board cable.
Bottom cover on page
Battery on page 36)
Display assembly on page
System board on page
System board on page
34), and then remove the following components:
44)
57)
57)
Component replacement procedures 69