Safe Stop Of The Frequency Converter - Danfoss VLT FC 102 Operating Instructions Manual

2 Safety

2.1.7 Safe Stop of the Frequency Converter

For versions fitted with a Safe Stop terminal 37 input, the frequency converter can perform the safety function
Stop Category 0 (as defined in EN 60204-1).
2 IEC 61800-5-2) or
It is designed and approved suitable for the requirements of Safety Category 3 in EN 954-1. This functionality is called Safe Stop. Prior to integration and
use of Safe Stop in an installation, a thorough risk analysis on the installation must be carried out in order to determine whether the Safe Stop functionality
and safety category are appropriate and sufficient. In order to install and use the Safe Stop function in accordance with the requirements of Safety
Category 3 in EN 954-1, the related information and instructions of the
Instructions are not sufficient for a correct and safe use of the Safe Stop functionality.
10
VLT HVAC Low Harmonic Drive Operating In-
Design Guide must be followed. The information and instructions of the Operating
®
MG.16.A1.02 - VLT is a registered Danfoss trademark
Safe Torque Off (As defined by draft CD
structions