11> Connecting The Interface Unit To A Controller; 12> Removal Of The Scale Unit - Magnescale SR138-025R Instruction Manual

<11> Connecting the interface unit to a
controller
1 Use the screw (M3×5) to mount the supplied fixing plate to
the interface unit.
2 Use the supplied screw (M4×5) to secure 1 to the mounting
surface.
Note
Prepare two M4 tap holes on the mounting surface.
20/0.79"
24 (E)
Fig. 3-22
<12> Removal of the scale unit
When removing a mounted scale unit from the machine, be sure
to secure the slider part to the scale part with the slider holder.
Follow the numerical sequence.
2 Secure the slider part using four M2.6 cap screws.
1 Peel off the
screening plate.
Fig. 3-23 Removing a scale unit
Securing the slider part to the scale part keeps the alignment of
the scale part and slider part after removal from the machine and
makes reinstallation easy.
3 Loosen screws and
remove them from
machine.