Magnescale SR138-025R Instruction Manual page 69

(4) When the bracket is mounted on the top of the
slider part
Align the mounting bracket with the top surface of the slider
part, and adjust the bracket so that the height from the scale
mounting surface is brought to 21±0.1mm/0.83"±0.004".
Ensure that the mounting bracket used comes in a shape that
accommodates the projecting part of the slider holder. As
shown in Fig. 3-11, secure the slider part using two cap
screws (M5×25 hexagonal socket head cap screws) and two
nuts (M5).
Projecting part of the slider
2-ø5.5
ø0.22"
37/1.46"
Mounting
0.24" to 0.31"t
bracket
Fig. 3-11
2-M5 nuts
(accessory)
2-M5×25
(accessory)
Slider part
6 to 8t 21±0.1
0.83"±0.004"
(5) When the bracket is mounted on the rear of the
slider part
Align the slider part rear side and mounting bracket without
loosening the screw securing the slider holder, and then
secure using the supplied two screws M4×8 while adjusting
the bracket height.
Mounting bracket
2-M4×8 (accessory)
Fig. 3-12
* The effective screw depth of the slider part is 4.5 mm.
If the mounting bracket has a thickness less than 4 mm,
use washers to adjust the thickness.
15/0.59"
(E) 17