Magnescale SR138-025R Instruction Manual page 50

Handling Precautions
Installation precautions
iv (E)
When installing this unit, care should be given to the following points to prevent noise
and electromagnetic wave interference from other equipment.
1. Do not pass lead and connection cables through the same ducts as power lines.
2. Be sure to install the unit at least 0.5 m/19.6" or more away from high voltage or
large current sources or high-power relays.
3. Absolutely do not bring the unit near magnets or sources of electromagnetic waves.
Note
• Magnet chucks and other sources of magnetic force of approx. 6 × 10
be kept at least 50 mm/19.6" or more away from the side surfaces and 10 mm/
0.39" or more away from the opening surfaces of the steel chassis on the scale
unit.
• If the unit must be installed close to sources of magnetic force, be sure to
implement adequate electromagnetic shielding countermeasures.
4. Be sure to ground the scale part and the slider part to prevent trouble to noise.
–2
[T] should