Set Parameters; Fundamentals; Set The Parameters - ABB EL6010 Operator's Manual

Chapter 5

Fundamentals

General Procedure
42/24-30 EN Rev. 1

Set Parameters

The normal procedure for setting parameters is:
1. Press Enter to access the menu.
2. Select the Parameters menu item with the
3. Activate the Parameters menu item with the Enter key.
4. Change the parameters with the
5. Confirm the change with the Enter key or cancel the change with the Back
key.
6. Use the Back key to return to the previous menu.
Only parameters that blink in the display can be edited.
The following example should clarify the details of this general procedure.
Step Action
1 Access the menu.
2 Select the "Setting
parameters" menu.
3 Select the submenu.
4 Select the parameter to
be changed.
5 Edit the parameter value
and confirm the change.
6 Return to the previous
menu.
7 Return to the previous
menu.
8 Return to the measured
value display.
EL6010 Gas Analyzer in Category 2G Operator's Manual
or key.
or key.
Key Display
CO 105.2 ppm
Calibrate
Enter
Setting parameters
Parameters component
Span setpoint
505.0 ppm CO
Span setpoint
505.0 ppm CO
Span setpoint
500.0 ppm CO
Parameters component
Setting parameters
CO 105.2 ppm
Key
Enter
Enter
CO
Enter
Enter
Back
Back
CO
Back
27