TANDBERG D14049.04 Administrator's Manual page 245

Tandberg video communications server administrator guide
Table of Contents

Advertisement

Grey Headline (continued)
Command reference - xConfiguration
Zones Zone [1..1000] TraversalServer H323 Port: <1024..65534>
Specifies the port on the VCS being used for H.323 firewall traversal from this traversal client.
Default: 6001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 5 TraversalServer H323 Port: 2777
Zones Zone [1..1000] TraversalServer H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal client.
Note: the same protocol must be set on the client for calls to and from this traversal server.
Default: Assent
Example: xConfiguration Zones Zone 5 TraversalServer H323 Protocol: Assent
Zones Zone [1..1000] TraversalServer Registrations: <Allow/Deny>
Controls whether proxied SIP registrations routed through this zone are accepted.
Default: Allow
Example: xConfiguration Zones Zone 5 TraversalServer Registrations: Allow
Zones Zone [1..1000] TraversalServer SIP Poison Mode: <On/Off>
Determines whether SIP requests sent out to this zone will be "poisoned" such that if they are received by the local VCS again they will be rejected.
On: SIP requests sent out via this zone that are received again by this VCS will be rejected.
Off: SIP requests sent out via this zone that are received by this VCS again will be processed as normal.
Default: Off
Example: xConfiguration Zones Zone 5 TraversalServer SIP Poison Mode: Off
Zones Zone [1..1000] TraversalServer SIP Port: <1024..65534>
Specifies the port on the VCS being used for SIP firewall traversal from this traversal client.
Default: 7001, incrementing by 1 for each new zone.
Example: xConfiguration Zones Zone 5 TraversalServer SIP Port: 5061
Zones Zone [1..1000] TraversalServer SIP TLS Verify Mode: <On/Off>
Controls X.509 certificate checking and mutual authentication between this VCS and the traversal client. If enabled, a TLS verify subject name must be specified.
Default: Off
Example: xConfiguration Zones Zone 5 TraversalServer SIP TLS Verify Mode: On
Zones Zone [1..1000] TraversalServer SIP TLS Verify Subject Name: <S: 0..128>
The certificate holder's name to look for in the traversal client's X.509 certificate (must be in either the Subject Common Name or the Subject Alternative Name attributes).
Example: xConfiguration Zones Zone 5 TraversalServer SIP TLS Verify Subject Name: "myclientname"
Overview and
System
Introduction
status
configuration
D14049.07
March 2010
VCS
Zones and
Clustering and
configuration
neighbors
peers
Call
Bandwidth
processing
control
245
TANDBERG
VIDEO COMMUNICATION SERVER
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
Appendices

Advertisement

Table of Contents
loading

Table of Contents