Table of Contents
Advertisement
Grey Headline (continued)
Restoring default configuration
It is possible to restore the VCS to its default configuration. This is done through the CLI using
xCommand
DefaultValuesSet. This command is not available through the web interface.
The DefaultValuesSet command allows you to specify the level of configuration to restore, from
1 to 3 as follows:
•
Level 1 resets most configuration items to their default value, with the exception of the Level 2
and Level 3 items shown in the tables below.
•
Level 2 resets configuration items mostly related to remote authentication (listed in
items reset by DefaultValuesSet level
•
Level 3 resets all critical configuration items (listed in
DefaultValuesSet level 3
below) plus Level 1 and Level 2 items to their default values.
Configuration item
Administration HTTP Mode
Administration HTTPS Mode
Administration SSH Mode
Administration Telnet Mode
Ethernet [1..2] IP V4 Address
Ethernet [1..2] IP V4 StaticNAT Address
Ethernet [1..2] IP V4 StaticNAT Mode
Ethernet [1..2] IP V4 SubnetMask
Ethernet [1..2] IP V6 Address
Ethernet [1..2] Speed
IPProtocol
IP DNS Domain Name
IP DNS Hostname
IP DNS Server [1..5] Address
IP Gateway
IP Route [1..50] Address
Overview and
System
Introduction
status
configuration
D14049.07
March 2010
2), plus Level 1 items to their default values.
Configuration items reset by
Configuration items reset by DefaultValuesSet level 3
VCS
Zones and
configuration
neighbors
Overview
The
xConfiguration reference
their default values.
xCommand DefaultValuesSet Level: 3 must be used with caution, as it resets the
!
system's IPv4 and IPv6 addresses, meaning you will no longer be able to access the system
over IP. It also deletes all option keys including pre-installed options such as Expressway
and the number of calls. It also deletes all links configured on the VCS, including the automatically
configured
default links
between the Default Subzone, Traversal Subzone and Default Zone. Without
Configuration
these links, calls will not be able to be placed. To restore these links, you should run the command
xCommand DefaultLinksAdd
can also be restored manually using the web interface - see the
for instructions on how to do this.
Default value after xCommand DefaultValuesSet Level: 3
On
On
On
Off
192.168.0.100
<blank>
Off
255.255.255.0
<blank>
Auto
IPv4
<blank>
<blank>
<blank>
127.0.0.1
<blank>
Clustering and
Call
Bandwidth
peers
processing
control
175
TANDBERG
VIDEO COMMUNICATION SERVER
table shows a full list of all configuration items and where applicable
after xCommand DefaultValuesSet Level: 3. These links
Creating and editing links
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
section
Appendices
Advertisement
Table of Contents
