Table of Contents
Advertisement
Grey Headline (continued)
Call IDs, Serial Numbers and Tags
Each call that passes through the VCS is assigned a Call ID and a Call Serial Number. Calls also
have a Call Tag assigned if this does not already exist.
Call ID
The VCS assigns each call currently in progress a different Call ID. The Call ID numbers start at 1
and go up to the maximum number of calls allowed on that system.
Each time a call is made, the VCS will assign that call the lowest available Call ID number. For
example, if there is already a call in progress with a Call ID of 1, the next call will be assigned a
Call ID of 2. If Call 1 is then disconnected, the third call to be made will be assigned a Call ID of 1.
The Call ID is not therefore a unique identifier: while no two calls in progress at the same time will
have the same Call ID, the same Call ID will be assigned to more than one call over time.
Call Serial Number
The VCS assigns a unique Call Serial Number to every call passing through it. No two calls on a
VCS will ever have the same Call Serial Number. A single call passing between two or more VCSs
will be identified by a different Call Serial Number on each system.
Call Tag
Call Tags are used to track calls passing through a number of VCSs. When the VCS receives a call,
it checks to see if there is a Call Tag already assigned to it. If so, the VCS will use the existing
Call Tag; if not, it will assign a new Call Tag to the call. This Call Tag is then included in the call's
details when the call is forwarded on. A single call passing between two or more VCSs will be
assigned a different Call Serial Number each time it arrives at a VCS (including one it has already
passed through) but can be identified as the same call by use of the Call Tag. This is particularly
useful if you are using a
remote syslog server
network.
The Call Tag also helps identify loops in your network - it is used as part of the automatic
detection
feature, and you can also search the Event Log for all events relating to a single call tag.
Loops occur when a query is sent to a neighbor zone and passes through one or more systems
before being routed back to the original VCS. In this situation the outgoing and incoming query will
have different Call Serial Numbers and may even be for different destination aliases (depending on
whether any transforms were applied). However, the call will still have the same Call Tag.
Call Tags are supported by VCS version X3.0 or later. If a call passes through a system that
is not a VCS, or a VCS that is running an earlier version of the software, the Call Tag
information will be lost.
Overview and
System
Introduction
status
configuration
D14049.07
March 2010
to collate events across a number of VCSs in your
VCS
Zones and
Clustering and
configuration
neighbors
Identifying calls
Identifying calls in the web interface
The Call summary, Call details and Search details pages shows the Call Tag. The Call details and
Search details pages also show the Call Serial Number.
The VCS web interface does not show the Call ID.
Identifying calls in the CLI
To control a call using the CLI, you must reference the call using either its Call ID or Call Serial
Number. These can be obtained using the command:
xStatus Calls
•
This will return details of each call currently in progress in order of their Call ID. The second line of
each entry will list the Call Serial Number, and the third will list the Call Tag.
Call loop
Call ID
Call
Bandwidth
peers
processing
control
115
TANDBERG
VIDEO COMMUNICATION SERVER
Call serial number
Firewall
Applications
Maintenance
traversal
ADMINISTRATOR GUIDE
Call Tag
Appendices
Advertisement
Table of Contents
