Pisn Users; Trunk Groups - Aastra 400 Series System Manual

4. 6. 2

PISN users

Number setting
The call number entered under
coming call. If the two numbers match up, the PISN user number is displayed as the
CLIP with NPI = private
CLIP selection setting
See "Internal call to a PISN User", page
4. 6. 3

Trunk groups

Call if NPI unknown
If a call with NPI = unknown
ringing pattern on the basis of this setting. It is also decided at the same time
whether the exchange access prefix (0-) should precede the CLIP number.
Truncate CLIP setting
A digit sequence can be configured here. If the sequence matches the initial digits
of the CLIP number received, the digits will be truncated. This setting is normally
used to remove any superfluous "0".
CLIP automatic setting
This setting is effective only if
group configuration.
If CLIP automatic = yes, the numbering plan identifier and type of number are left
unchanged.
If CLIP automatic = No, the numbering plan identifier and type of number are taken
from the trunk group setting, but not the actual CLIP number. This may be neces-
sary in cases where connected third-party systems do not process numbering plan
identifiers and types of number correctly.
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
Number is compared with the CLIP number of an in-
and TON = level 0.
94.
setting
is received, it is signalled with the internal or external
Network type
Identification elements
= private has been set in the trunk
95