Table of Contents
Advertisement
Introduction
Batch programming enables users to integrate a batch of commands into a single batch barcode.
Listed below are batch programming rules:
1. Command format: Command + "=" + Parameter Value.
2. Each command is terminated by a semicolon (;). Note that there is no space between a command and
its terminator semicolon.
3. Use the barcode generator software to generate a 2D batch barcode.
Example: Create a batch barcode for Illumination Always On (0200010), Sense Mode (0302010),
Decode Session Timeout (0313000) = 2s:
1. Input the commands:
0200010;0302010;0313000=2000;
2. Generate a batch barcode.
When setting up a scanner with the above configuration, scan the Enable Batch Barcode barcode
and then the batch barcode generated.
141
Chapter 11 Batch Programming
Enable Batch Barcode
Enter Setup
** Exit Setup
Advertisement
Table of Contents
