Connecting The Hms 400 Server To Power - Avaya 400 Installation And Commissioning Manual

Hospitality messaging server
Hide thumbs Also See for 400:
Table of Contents

Advertisement

HMS 400 hardware installation
Prerequisites:
• To install the modem, the following items are required:
- An analog modem that includes an analog RJ-11 analog phone cord and US Robotics
56 Kb/s USB modem. The Avaya order code for North America only is NTUB30HA.
Other regions must supply an equivalent USB modem.
- An analog line jack.
Procedure
1. To connect the modem, connect the B end of the USB A-B cable into the back of
2. Connect the A end of the USB A-B cable into an available USB port on the rear of
3. Connect one end of the telephone cable into the modem RJ-11 jack that is labeled
4. Connect the opposite end of the telephone cable into the RJ-11 wall jack.

Connecting the HMS 400 server to power

About this task
Ensure that proper power and grounding are available for all the power outlets that serve the
HMS 400 server and associated peripherals. Power for these devices must be wired and fused
independently of all other receptacles and referenced to the same ground as the CS 1000.
When the server connects to an AC power source but is not on, the operating system does
not run, and all core logic except for the service processor (the baseboard management
controller or optional Remote Supervisor Adapter II SlimLine) is shut down. The server can
respond to requests from the service processor, such as a remote request to turn on the server.
The power-on LED flashes to indicate that the server is connected to AC power but is not
on.
Warning:
Use the connecting cables, power cord, and AC adaptors shipped with the equipment or
specified by Avaya. If you use any other equipment, it can cause failures, malfunctions, or
fire. Use power cords shipped only with this equipment. Not following these guidelines can
lead to death or severe injury.
Warning:
Risk of personal injury and risk of hardware failure
You must connect the power outlets that are used by the HMS 400 server and the peripheral
devices to the same single-point ground reference as the one used by the CS 1000 switch
50
Avaya Hospitality Messaging Server 400 Installation and Commissioning
the modem.
the server.
LINE.
Comments? infodev@avaya.com
March 2012

Advertisement

Table of Contents
loading

Table of Contents