Using Finger Touch Operations - Epson BrightLink 1480Fi User Manual

8. If the cursor location and your finger position do not match, repeat these steps to calibrate again.
Parent topic:
Related concepts
Pen Calibration
Related references
Pen and Touch Setup Settings - Pen/Touch Menu
Installation Settings - Installation Menu

Using Finger Touch Operations

You can use your finger to interact with the projected screen, just as you would use an interactive pen.
You can use either a pen or your finger, or use both at the same time.
When performing touch operations with your finger, you can use up to six fingers (depending on the
interactive mode, operating system, and connection type).
Note: A Touch Unit is optional for the BrightLink 1480Fi and must be installed for finger touch operation.
1. Install the Touch Unit as described in the online Installation Guide.
Note: If you are using an older Touch Unit, refer to the installation guide for that model.
2. Turn on your projector. This automatically turns on the Touch Unit also.
The blue light on the Touch Unit turns on.
Note: If the blue light does not turn on, press the Menu button on the remote control and make sure
the Installation > Touch Unit > Power setting is set to On.
3. Calibrate the pens.
Using Finger Touch Interactivity
224