Solutions When You Cannot Operate A Computer From The Projected Screen; Solutions For Problems With Capturing, Printing, Saving, Or Scanning - Epson BrightLink 1480Fi User Manual

Solutions When You Cannot Operate a Computer from the Projected Screen

If you are unable to access a computer from the projected screen, try the following solutions:
• Make sure the USB Display setting in the Signal I/O menu is set to On.
• Make sure you perform pen calibration when using the interactive pen for the first time so that the
projector recognizes the position of the pen correctly.
• Make sure PC Interactivity is turned on in the projector's interactive toolbar.
• Make sure the USB cable is securely connected. Disconnect the USB cable, and then reconnect it.
• When you are connecting your computer to the projector's USB-B2 port, make sure the USB-B2
setting in the Pen/Touch menu matches the HDMI input your computer is connected to.
• When connecting your computer to either of the control pad's (BrightLink 1485Fi) HDMI ports, make
sure to connect your computer to the USB-B port on the control pad and not directly to the projector.
Parent topic:

Solutions for Problems With Capturing, Printing, Saving, or Scanning

If you are having trouble capturing and pasting, or printing, saving, or scanning, try the following
solutions:
• If you are having trouble pasting a captured image, make sure the image is not HDCP protected.
• If a black frame appears around a pasted image, it may be because the image was shifted or resized.
• Connect only one printer or multifunction device at a time, and make sure the device is supported by
the projector.
• If you are having trouble printing or scanning, make sure the printer is not out of ink, jammed, or in any
other error state.
• For USB printing or scanning, make sure the printer is connected to the USB-A port on the projector or
control pad (BrightLink 1485Fi). If you are using the control pad, make sure a USB cable is connected
between the projector's USB-A port and the upper USB-B port on the control pad.
• For USB printing or scanning, try connecting a different USB cable, and make sure the cables are less
than 16 feet (4.9 m) long.
• Check the settings on the Interactive menu.
Parent topic:
Related references
Interactive Settings - Interactive Menu
Solving Interactive Problems
Solving Interactive Problems
354