Using Finger Touch Operations - Epson BrightLink 697Ui User Manual

When you get to the bottom of a column, the next circle appears at the top of a new column.
Note: If you make a mistake, press the Esc button on the remote control to go back to the previous
circle. To restart the calibration process, press and hold the Esc button for 2 seconds.
9. If the cursor location and your finger position do not match, repeat these steps to calibrate again.
Parent topic:
Related concepts
Pen Calibration

Using Finger Touch Operations

You can use your finger to interact with the projected screen, just as you would use an interactive pen.
You can use either a pen or your finger, or use both at the same time.
When performing touch operations with your finger, you can use two fingers in built-in annotation mode
and up to six fingers in whiteboard mode.
1. Install the Touch Unit as described in the Touch Unit and Control Pad Installation Guide.
2. Turn on your projector. This automatically turns on the Touch Unit also.
Using Finger Touch Interactivity
200