How To Read These Operating Instructions - Danfoss VLT Automation Drive FC 300 Operating Instructions Manual

®
VLT Automation Drive FC 300
Operating Instructions High Power

1. How to Read these Operating Instructions

1.1. How to Read these Operating Instructions
1.1.1. How to Read these Operating Instructions
The frequency converter is designed to provide high shaft performance on electrical motors. Please
read this manual carefully for proper use. Incorrect handling of the frequency converter may cause
improper operation of the frequency converter or related equipment, shorten lifetime or cause
other troubles.
These Operating Instructions will help you get started, install, program, and troubleshoot your
frequency converter.
Chapter 1, How to Read these Operating Instructions, introduces the manual and informs
you about the approvals, symbols, and abbreviations used in this literature.
Chapter 2, Safety Instructions and General Warnings, entails instructions on how to handle
the frequency converter correctly.
Chapter 3, How to Install, guides through mechanical and technical installation.
Chapter 4, How to Programme, shows how to operate and programme the frequency converter
via the Local Control Panel.
Chapter 5, General Specifications, contains technical data about the frequency converter.
Chapter 6, Warnings and Alarms, assists in solving problems that may occur when using the
frequency converter.
Available Literature for FC 300
-
-
-
-
-
-
Danfoss Drives technical literature is also available online at www.danfoss.com/drives.
®
The VLT Automation Drive FC 300 Operating Instructions provide the neccessary in-
formation for getting the drive up and running.
®
The VLT Automation Drive FC 300 Design Guide entails all technical information about
the drive design and applications including encoder, resolver and relay options.
®
The VLT Automation Drive FC 300 Profibus Operating Instructions provide the infor-
mation required for controlling, monitoring and programming the drive via aProfi-
busfieldbus.
®
The VLT Automation Drive FC 300 DeviceNet Operating Instructions provide the in-
formation required for controlling, monitoring and programming the drive via aDevice-
Netfieldbus.
®
The VLT Automation Drive FC 300MCT 10 Operating Instructions provide information
for installation and use of the software on a PC.
®
The VLT Automation Drive FC 300 24 V DC Backup Instruction provides information
for installing the 24 V DC Backup option.
MG.33.U1.02 - VLT ® is a registered Danfoss trademark
1. How to Read these Operating Instructions
1
3