Danfoss VLT Automation Drive FC 300 Operating Instructions Manual page 32

3. How to Install
The E1 enclosure is always delivered with a
pedestal as standard. Install the pedestal on
the floor. Fixing holes are to be drilled accord-
ing to this figure:
3
Mount the drive on the pedestal and fix it with
the included bolts to the pedestal as shown on
the illustration.
32
Illustration 3.23: Drill master for fixing holes in
floor.
Illustration 3.24: Mounting of drive to pedestal
MG.33.U1.02 - VLT ® is a registered Danfoss trademark
®
VLT Automation Drive FC 300
Operating Instructions High Power