Danfoss VLT Automation Drive FC 300 Operating Instructions Manual page 22

3. How to Install
Wire access
Ensure that proper cable access is present including necessary bending allowance. As the IP00
enclosure is open to the bottom cables must be fixed to the back panel of the enclosure where
the frequency converter is mounted, i.e. by using cable clamps.
Terminal locations
(D1 and D2 enclosures)
3
Take the following position of the terminals into consideration when you design for cables access.
Illustration 3.8: Position of power connections
Illustration 3.9: Position of power connections - Disconnect
Be aware that the power cables are heavy and hard to bend. Consider the optimum position of
the frequency converter for ensuring easy installation of the cables.
22
MG.33.U1.02 - VLT ® is a registered Danfoss trademark
®
VLT Automation Drive FC 300
Operating Instructions High Power