Related Manuals for Danfoss Holip HLP-A Series
Summary of Contents for Danfoss Holip HLP-A Series
- Page 2 HLP-A Series...
- Page 4 HLP-A Series I. Introduction 1. Checks upon Delivery 2. Nameplate Description of HLP Series Inverter II. Safety Precautions 1. Before the Power-up 2. During the Power-up 3. During the Operation III. Standards and Specifications 1. Particular Specifications 2. General Specifications IV.
- Page 5 HLP-A Series X. Care & Maintenance, Fault Information and Troubleshooting 82 1. Precautions about Inspection and Maintenance 2. Periodical Inspection and Maintenance items 3. Fault Indication and Troubleshooting 4. Faults and Analysis XI. Selection of Peripheral Devices and Disposition 1. Options 2.
- Page 6 HLP-A Series I. Introduction Thank you for purchasing and using the general-purpose inverter of HLP series of multi-functions and high performance. Please read carefully the operation manual before putting the inverter to use so as to correctly install and operate the inverter, give full play to its functions and ensure the safety.
-
Page 7: Checks Upon Delivery
HLP-A Series Caution ● Do not make any voltage-withstanding test with any component inside the inverter. These semi-conductor parts are subject to the damage of high voltage. ● Never connect the AC main circuit power supply to the output terminals U.V W of the inverter. ●... - Page 8 HLP-A Series 2. Nameplate Description of HLP Series Inverter MODEL: HLPA07D543B INPUT: 3PH380V50Hz OUTPUT: 3PH380V17.5A7.5KW Freq-Range: 0.1~400Hz HOLIP ELECTRONICS CO., LTD. Model: HLP A 07D5 43 B hardware Version Voltage Rating, 43 means 3-phase 380V Inverter Capacity, 07D5 means 7.5KW Serial No., A means A series Trade Mark HLP-A Series...
-
Page 9: Safety Precautions
HLP-A Series II. Safety Precautions 1. Before the Power-up Caution ● Check to be sure that the voltage of the main circuit AC power supply matches the input voltage of the inverter. ● The symbol, , represents ground terminals. Be sure to make correct ground connection of the earth terminals of the motor and the inverter for safety. - Page 10 HLP-A Series ● Be su re to t u r n off the power supply before dissembling or assembling the operation keypanel and fixing the front cover to avoid bad contact causing faults or non-display of the operator. ● Do not install the inverter in a space with explosive gas to avoid the risk of explosion.