EdilKamin IDROPELLBOX 30 Installation, Use And Maintenance Manual page 26

ON MODE with STAND BY
In ON mode with STAND BY (the product is "active"
but with stand by function enabled) the product turns
on only with heating demand. If the Stand By function
is active, the display shows the same information as in
the ON state without flame (on the top left you will see
"STB").
The LCD shows the following information:
• product mode (STB)
• the current time
• the room temperature (or the mode of the room
thermostat)
• the activation of the timer programming if present
(Timer/Crono)
ALARM MODE
26
In case of Shutdown due to alarm, the display shows
the type of alarm. See the paragraph "Troubleshooting"
USER INSTRUCTIONS
If the product was operating, it switches to minimum
power and waits for the set time before going off.
If the product was in the ignition phase, it completes
the ignition phase and switches to minimum power
and waits for the set time before going off.
If the product was OFF and is switched to ON, the
stove goes immediately to stand-by without ignition.
USER
While in stand-by mode, and ON, the
product turns on only if there is a heat
request.