EdilKamin IDROPELLBOX 30 Installation, Use And Maintenance Manual page 11

PUMP SPECIFICATIONS
Fig. 1:
A
The pump has no adjustment devices.
Fig. 2: Adjustments are made via the micro
processor on the boiler stove: "begin" at the lowest speed and make adjustments based on the progression of the
RKA
water temperature. Below is the descriptions for the LED signals.
LEDS
Steady green
Flashing green light
Fig. 3a:
Steady red LED
H
H max
Flashing red LED
Hs
1
/ Hs
2
H min
Flashing red/green light
WATER CIRCUIT INSTALLATION
MEANING
Pump running
Pump in stand-by mode Normal operation
Fig. 3b:
Stall
H
Contact/winding
H max
Under-/over-voltage
Hs
Excessively high module
temperature
H min
Turbine-based operation
Q
Dry operation
Overload
B
leds
RKC
CAUSE
Normal operation
Pump stalled
Defective winding
Supply voltage too low/high
Motor board temperature too
high
The pump is not powered but
the hydraulic system is fed by
other sources
Q
Air in the pump
The motor runs with difficulty
INSTALLER
SOLUTION
Contact the TAC
Check the supply
voltage/contact the TAC
Check the network voltage/
water pressure and
environmental
conditions/contact the TAC
11