YOKOGAWA AXG1A Installation Manual page 35

(4) Waterproof Gland with JIS G3/4 Female
Remote Sensor
Optional code: EW
Gasket
Washer
G1/2
G3/4
When working on conduit or flexible tube (G3/4)
* When connecting G1/2, remove the conversion plug and
connect directly to cable entry.
Remote Transmitter (AXG1A/AXFA11)
Optional code: EW5 (AXG1A), EW (AXFA11)
When working on conduit or
flexible tube (G3/4)
G1/2
G3/4
Extension plug (x2)
Conversion plug (x5)*
Cable
* When connecting G1/2, remove the conversion plug
and connect directly to cable entry.
Conversion plug (x2)*
Cable
F0417.ai
Gasket
Washer
F0418.ai
<4. Wiring>
4.3.2 Conduit Wiring
When wiring the conduits, utilize the waterproof gland to
prevent water from flowing in through the conduit. Place
the conduit pipe on an angle as shown in the following
figures.
Install a drain valve at the low end of the vertical pipe, and
open the valve regularly.
To prevent noise, please do not use the same conduit for
signal cable and power cable.
Drain valve
Figure 4.3.1 Integral Flowmeter
Drain valve
Figure 4.3.2 Remote Sensor
Drain valve
Figure 4.3.3 Remote Transmitter (AXW4A)
Drain valve
Figure 4.3.4 Remote Transmitter (AXG1A, AXFA11)
34
F0419.ai
F0420.ai
F0421.ai
F0422.ai
IM 01E24A01-01EN