Point Data Tab (Breakpoint Table); Totals - Thermo Scientific DensityPRO-T Series User Manual

Operation
Application Screens
Point Data Tab
(Breakpoint Table)

Totals

-
4 64 DensityPRO User Manual
Selecting Breakpoint Table as the density calibration method on the CAL Data tab,
introduces a different set of fields on the Point Data tab of the Gauge Calibration
screen. The breakpoint table displays the density of each calibrated point, as well as the
point's count rate and calibration/standardization ratio.
Figure 4-32. Application Screen, Gauge Calibration Point Data Tab (Breakpoint Table)
Additionally, this tab allows the user to view displayed point data, to change the point
data by manually entering new values, and to submit or delete point data.
The purpose of the totalizers is to calculate the amount of mass or volume flow
measured by a gauge over a period of time. There are four totalizers available for each
detector, and each totalizer can be configured to totalize mass or volume flow.
To access the information on Application Totals tabs using only the remote
transmitter keypad, see Figure A-19.
Thermo Scientific