Advertisement
63A0
Reference Code
Description/Action Perform all actions before exchanging Failing Items
9101
Fibre Channel interface error detected
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the Fibre Channel cable is correctly connected to the ports.
2. Clean the Fibre Channel connectors.
3. If there is a hub attached, verify that the hub is operational.
4. If there is a gateway device attached, refer to the gateway device
service documentation for additional problem analysis procedures.
5. refer to the tape device service documentation for additonal problem
analysis procedures.
9102
Gateway device detected a SCSI interface error
Use the gateway device service documentation to analyze the problem.
9200
I/O processor addressed the tape unit; no response
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
9201
Tape unit command timeout
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
9202
Tape unit failed after Licensed Internal Code was loaded
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the device is powered on.
2. If an interposer is required, make sure that it is connected between the
I/O processor and the SCSI cable.
3. Ensure that the SCSI cable is seated correctly, and that there are no bent
or damaged pins on the SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
9210
Illegal or unsupported tape unit response
178
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
Failing Item
FCIOA
FCDEV
FCCABLE
FI00871
FCGATE
FI00872
DEVTERM
FI00871
FI01112
FI00872
DEVTERM
FI00871
FI01112
FI00872
DEVTERM
MH7TMED
FI00871
FI01112
FI00872
DEVTERM
FI00871
FI01112
FI00130
Advertisement
