Suitable For Use - Britax safe-n-sound BS7300N-020133 Series Instructions For Installation & Use

SPECIAL FEATURES
23
24
22
21
20
19
18
13. Adjustable Top Tether Strap
14. Attachment Clip
15. Car's Anchor Fitting
16. Vehicle seatbelt
17. Blue REARWARD FACING BELT PATH label
18. Messy Mat™ (if supplied)
19. Recline Position Indicator
18
Instructions for Installation & Use - Series No. BS7300N-020133
-
REARWARD-FACING
13 14
15
Front of Vehicle
17 16
20. Recline Foot in Rearward Facing mode
21. Upper Lock-off (Forward Facing only) (If fitted)
22. Top Tether Storage Pocket
23. Top Tether Adjuster
24. Top Tether Adjustment Strap
25. Harness Adjustment Lever (under trim flap)
Continue to use this child restraint in the rear facing mode
until the child's shoulders reach the limit of the lower or middle
shoulder height marker before turning the seat to face forward. A
younger child's neck muscles may be unable to support their head
thus the child should remain rear facing until the neck muscles
become stronger.
The purchaser should check the measurements between the
8
front of the seat back of the rear seat and all front seats in the
car in which the child restraint is intended to be used, to ensure that the space is sufficient. If you have the
restraint check it fits in your car. The length may be longer when the headrest is raised when rear facing.
25
DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT
STABILISING BAR FULLY EXTENDED.
Do not use the restraint without the top tether strap correctly attached.
DO NOT USE A REAR FACING CHILD RESTRAINT WHERE AN
AIRBAG IS FITTED IN FRONT OF THE SEATING POSITION.
Do not use on any vehicle seat which faces sideways or rearwards.
Never leave babies or toddlers in a stationary car in the sun because of the risk of heat exhaustion.
Ensure babies and toddlers have adequate ventilation and are shaded from direct sunlight through side or
rear windows.
CHILD RESTRAINT UPPER ANCHORAGE FITTING
To use this child restraint, the car will need a child restraint upper anchorage fitting in the seating position
that you intend to use. Refer to the car owner's handbook.
The upper anchorage fitting is required for attaching the top tether in both rear facing mode and forward
facing mode covered later in the these instructions.
If no upper anchorage fitting is provided then you will need to install an upper anchorage fitting. Refer to
pages 83 to 86.

SUITABLE FOR USE

400mm
Seat width 440mm
Do not allow the front seat to
alter the installed angle of the
allow the restraint to touch the
Instructions for Installation & Use - Series No. BS7300N-020133
530mm
restraint. It is permissible to
front vehicle seat.
19