Connect The Electromatic; Check The Installation - KaVo ELECTROmatic M Instructions For Use Manual

▪ 4x + 2x Screws M4x12 ④ with self-locking nuts ①
▪ 4x + 2x Washers ②
▪ Optional: 4x Spacer bolts, 35 mm ⑦
▪ Optional: 1x Mounting plate
▪ 2x Plastic screws ⑥
▶ Open the cabinet.
▶ Define the position of the control panel in the cabinet or on the wall and
draw a hole pattern for attachment. If possible, use existing screws or per-
forations as screw positions.
▶ Installation in a cabinet: Use 2 plastic screws to screw the control panel to
the cabinet.
▶ Installation on the wall: Use 2 screws ④ and washers ② to screw the
mounting bracket with control panel to the wall and secure it with the nuts
①.
▶ Mount the control unit.
See also:
2 4.4 Installation position 1: Mount below a holder, Page 34

4.8 Connect the ELECTROmatic

See also:
2 5.1.2 Connect the ELECTROmatic, Page 48
2 5.1.5 Connect the power supply, Page 50

4.9 Check the installation

▶ Check if the fastening is secure.
▶ Perform the startup.
See also:
2 5 Startup, Page 48
Instructions for use ELECTROmatic M/C and PM/PC
4 Installation | 4.8 Connect the ELECTROmatic
47 / 80