Table of Contents
Advertisement
Machine head
To set the point in time for cutting:
1. Loosen the threaded pins (4).
2. Press and turn the hand crank until the thread-pulling knife (6) can be
3. Pivot the thread-pulling knife (6) as far forward until the circle mark is
4. Press and turn the hand crank until the thread lever is at the top dead
5. Push the control cam (3) to the left as far as it will go and against the
6. Turn the control cam (3) such that the roller (1) runs up at the contour
7. Tighten the threaded pins (4).
8. Check the setting:
Service Instructions 911-211 - 02.0 - 10/2016
swung out by hand.
exactly next to the tip of the counter blade (5).
center.
clamping ring (2).
of the control cam (3) and the widest extent of the control cam is at the
highest point when the thread lever is at the top dead center.
• Insert the thread into thread-pulling knife (6) and slowly press and
turn the hand crank.
• Determine the hand crank position at which the thread is cut.
• Repeat setting steps 1 – 7 if necessary.
66
Advertisement
Table of Contents
