Table of Contents
Advertisement
Machine head
4.4.3 Setting the hook side clearance
Order
First, check the following settings:
• A straight and undamaged needle has been inserted ( Operating
• Needle bar linkage ( p. 33)
• Loop stroke position ( p. 34)
Proper setting
Machine locked in place at position 1 ( p. 28).
Maximum 0.1 mm distance between the hook tip and the groove for
Cover
• Swivel up the machine head ( p. 15)
Service Instructions 911-211 - 02.0 - 10/2016
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you check and set
the hook side clearance.
Instructions)
NOTICE
Property damage may occur!
There is a risk of machine damage, needle breakage or damage to
the thread if the distance between needle groove and hook tip is
incorrect.
Check and, if necessary, readjust the distance to the hook tip after
inserting a new needle with a different size.
the needle.
38
Advertisement
Table of Contents
