Table of Contents
Advertisement
Fig. 45: Setting the height of the thread-pulling knife
(1) - Counter blade
(2) - Thread-pulling knife
(3) - Hook bearing
To set the height of the thread-pulling knife:
1. Loosen the screw (6).
2. Remove the thread-pulling knife (2).
3. Place as many washers between thread-pulling knife (2) and knife
4. Non-required washers on the top side between the thread-pulling
5. Screw down the thread-pulling knife (2) using screw (6).
61
carrier (4) as necessary to ensure that the upper edges of counter
blade (1) and thread-pulling knife (2) are at the same height.
knife (2) and screw (6) should be kept.
(4) - Knife carrier
(5) - Distance
(6) - Screw
Service Instructions 911-211 - 02.0 - 10/2016
Machine head
Advertisement
Table of Contents
