Machine head
4. Tap on Nähfußhub (Sewing foot stroke).
5. Enter a sewing foot height of 1.0 mm.
6. Move to position.
7. Turn the sewing foot to bottom dead center.
The distance between the throat plate and sewing foot must be 1 mm.
Fig. 39: Setting the sewing foot height
(1) - Screw
(2) - Nut
8. Loosen the screw (3).
9. Turn the pivot shaft so that the distance between throat plate and sew-
10. Tighten the screw (3).
11. Turn the sewing foot to top dead center.
The distance between the throat plate and sewing foot must be 5 mm.
12. Loosen the nut (2).
13. Adjust the screw (1) so that the distance between the throat plate and
Information
The distance between minimum and maximum positions may have to be
determined. If one of these settings is changed the other setting must be
checked again.
Service Instructions 911-211 - 02.0 - 10/2016
①
②
ing foot is 1 mm.
sewing foot is 5 mm (corresponding to a 4 mm sewing foot stroke).
③
(3) - Screw
54