Error Codes - Elation FUZE PROFILE CW User Manual

E R R O R C O D E S

ERROR CODES

PAN Er
TILT Er
RotGobo
GoboIndex
Iris
Blade
Zoom
Focus
Frost
HeadTemp
CoolFan1
CoolFan2
CoolFan3
CoolFan4
BaseTemp
BaseFan
Error Codes subject to change without notice.
DESCRIPTION
Movement is not located in the default position after the reset.
These messages will appear after a fixture reset if the magnetic-
indexing circuit malfunctions (sensor failed, or magnet is missing)
or there is a motor failure (defective motor or a defective motor IC
drive on the main PCB). This error may also be displayed if the
head/yoke was blocked during a reset function.
Movement is not located in the default position after the reset.
These messages will appear after a fixture reset if the magnetic-
indexing circuit malfunctions (sensor failed, or magnet is missing)
or there is a motor failure (defective motor or a defective motor IC
drive on the main PCB).
These messages will appear if there is a temperature and/or fan
malfunction.
30