Table of Contents
Advertisement
E R R O R C O D E S
When the unit is powered on, it will automatically enter a "Reset/Test" mode, which brings all
the internal motors to a home position. If an internal problem with one or more of the motors
is detected, an error code will flash in the display in the form of "XX Er" where XX will repre-
sent a code associated with the detected error. These codes are listed in the table accompa-
nying this section.
For example, when the display shows "PAN Er" it means there is some type of error with the
Pan motor. If there are multiple errors during the start-up process, they will all flash in the
display. For example: if the fixtures has errors related to pan, tilt, and CMY all at the same
time, you will see the error message "PAN Er", "TILT Er", and "CMY Er" flash and repeat 5
times.
If an error is detected during the initial start-up procedure, the fixture will self-generate a
second reset signal and try to realign all the motors and correct the errors. If the error per-
sists after a second attempt, a third attempt will be made. If after a third attempt all the
errors have not been corrected the fixture will make the following determinations:
• 3 or More Errors: The fixture cannot function properly with three or more errors, and
therefore the fixture will place itself in stand-by mode until subsequent repairs can be
made.
• Less Than 3 Errors: The fixture has less than 3 errors. Most other functions will work
properly. The fixture will attempt to operate normally until the errors can be corrected
by a technician. The errors in question will remain flashing in the display as a reminder of
internal errors.
34
Advertisement
Table of Contents
