Error Codes - Elation Artiste Van Gogh EAV259 User Manual

E R R O R C O D E S
When power is applied, the unit will automatically enter a "Reset/Test" mode. This mode brings all
the internal motors to a home position. If there is an internal problem with one or more of the motors
an error code will flash in the display in the form of "XXer" were as XX will represent a function number.
For example, when the display shows "0Er" it means there is some type of error with the Pan motor.
If there are multiple errors during the start-up process, they will all flash in the display. For example: if
the fixtures have errors on Channel 1, 2, and 5 all at the same time, you will see the error message
"01Er", "02Er", and "05Er" flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a second reset
signal and try to realign all the motors and correct the errors. If the error persists after a second attempt
a third attempt will be made. If after a third attempt all the errors have not been corrected the fixture
will make the following determinations:
3 or More Errors - The fixture cannot function properly with three or more errors therefore the fixture
will place itself in a stand-by mode until subsequent repairs can be made.
Less Than 3 Errors - The fixture has less than 3 errors; therefore, most other functions will work
properly. The fixture will attempt to operate normally until the errors can be correct by a technician.
The errors in question will remain flashing in the display as a reminder of internal errors.

ERROR CODES

PAN Er
TILT Er
Cyan Color Wheel Er
Magenta Color Wheel Er
Yellow Color Wheel Er
CTO Wheel Er
Color Wheel Er
Focus Wheel Er
Zoom Wheel Er
Blade 1 Wheel Er
Blade 2 Wheel Er
Blade 3 Wheel Er
Blade 4 Wheel Er
All Blade Rot Wheel Er
Frost Wheel Er
Error Codes subject to change without notice.
DESCRIPTION
Movement is not located in the default position after the reset.
This message will appear after a fixture reset if the magnetic-indexing
circuit malfunctions (sensor failed, or magnet is missing) or there is a
motor failure (defective motor or a defective motor IC drive on the main
PCB). This error may also be displayed if the head/yoke was blocked
during a reset function.
Movement is not located in the default position after the reset. This
message will appear after a fixture reset if the magnetic-indexing
circuit malfunctions (sensor failed, or magnet is missing) or there is a
motor failure (defective motor or a defective motor IC drive on the
main PCB).
34