Before You Start The Engine; Starting The Engine - Zetor Major 80 Operator's Manual

BEFORE YOU START THE ENGINE

Before you start the engine, make
sure that:
1. tractor is properly braked
2. PTO shaft drive engagement
lever is in neutral position
3. the main gear shifting lever is
in neutral position
If the clutch pedal is not depressed, it is
not possible to start the engine – switch
for securing start is not switched.
Note: Before starting we recommend to
pressurize fuel system
heaves of manual feeding pump.
DRIVING OPERATION

STARTING THE ENGINE

1. Insert the key to the switch box - posi-
tion "0".
2. Depress
breaker is switched).
3. Shift reversing lever to neutral posi-
tion (start breaker is switched).
4. Pull manual clutch lever (start breaker
is switched).
5. Set the manual fuel control lever to
idle run position.
6. Switch the key of switch box from
position "0" to position "I". Thermostart
by several ignition control lights up. Wait for the
time when ignition control goes out
(the time is dependent on the tem-
perature of coolant).
the clutch pedal (start
40
If ignition control starts only blink-
ing instead of lighting, there is a
failure in the ignition system (ch.
Ignition system failure signaliza-
tion). Have the signalized failure
removed in a service.
7. As soon as the control goes out (5 s
max) turn the key from the position to
position "II" (start).
8. After starting the engine, release the
key immediately, it automatically re-
turn to position "I". Do not start
longer than 15 s.
NM13N051