Honeywell IntelliPath Series Installation And Setup Manual page 37

PROMPTS
Zn7 Trigger Type
64
(V+)_
Invert Zn7 Y/N
65
(N)_
Restore Zn7 Y/N
66
(Y)_
Delay Zn7 (secs)
67
(00)_
Rpt Zn7 ONLY if
68
Armed (N)_
Restore Zn8 Y/N
69
(Y)_
Delay Zn8 (secs)
70
(00)_
Prompts 71-77 appear only if communication path includes IP.
Use DHCP Y/N
71
(Y)_
NIC IP Address:
72
255.255.255.255_
Subnet Mask:
73
255.255.255.255_
Gateway IP Addr:
74
255.255.255.255_
DNS Serv IP
75
Addr:
255.255.255.255_
Enable Pwr Save
76
(N)_
OPTIONS
 (V+)
 (V–)
 (EOLR)
[Y], [N]
[Y], [N]
[01-15]
[00] = no delay
[Y], [N]
[Y], [N]
[01-15]
[00] = no delay
[Y], [N]
12 digit:
xxx.xxx.xxx.xxx
12 digit:
xxx.xxx.xxx.xxx
12 digit:
xxx.xxx.xxx.xxx
12 digit:
xxx.xxx.xxx.xxx
[Y], [N]
Section 3: Programming the Communicator
DESCRIPTION
Selects the triggering method for this zone input.
Press the [space] key to scroll through choices.
UL/ULC: V+ must be set as inverted and V– as
non-inverted.
Inverts the alarm and normal states of the zone 7 trigger;
otherwise uses normal input signal.
Enables restore reporting for zone 7.
Zone Trigger mode: This question will only be displayed if zone
7 is not used as the conditional (arming) trigger zone.
UL/ULC: Must be set to "Y."
Defines the reporting delay in seconds for zone 7.
Zone Trigger mode: This question will only be displayed if zone
7 is not used as the conditional (arming) trigger zone.
UL/ULC: Must be set to "00."
Reports alarms on zone 7 ONLY if the conditional zone is
triggered (armed).
If [N], always reports alarms on zone 7.
Enables restore reporting for zone 8.
UL/ULC: Must be set to "Y."
Defines the reporting delay in seconds for zone 8.
UL/ULC: Must be set to "00."
Dynamically allocates the IP addresses (recommended); then skip
to Prompt 76: "Enable Pwr Save". If [N], uses fixed IP addresses.
Enter the 4-part address for this device. The 4 parts of the
address must be separated by spaces (displayed as periods in
Review mode).
Enter the 32-bit address mask used to indicate the portion (bits) of
the IP address that is being used for the subnet address. The 4
parts of the address must be separated by spaces (displayed as
periods in Review mode).
Enter the 4-part address assigned to the Gateway. The 4 parts of
the address must be separated by spaces (displayed as periods
in Review mode).
Enter the 4-part IP address assigned to the DNS (Domain Name
System) server. The 4 parts of the address must be separated by
spaces (displayed as periods in Review mode).
To meet the 24 hour UL battery backup requirement, choose "Y"
to enable this feature. If this causes connectivity problems with
certain routers or switches, then choose "N" and wire the
communicator so it is powered from a UL listed UPS.
33