Supervision Features; Antennas - Honeywell IntelliPath Series Installation And Setup Manual

LTE-I Installation and Setup Guide

Supervision Features

The communicator provides the following types of supervision and fault detection:
 Network communication failure: In the event the AlarmNet network does not hear a
supervisory message from the communicator within a specified time, AlarmNet notifies the
central station of a communication failure.
 Communication path failure: When the communication path is set to IP & Cell, both the Central
Station and the control panel can be notified of a communication path failure. Both failures are
considered true faults when the respective fault times have expired ("Cell Fault Time" and "IP
Fault Time" options) provided it has been set to a non-zero value. Notification is sent to the
central station upon this expiration. Notification to the panel is controlled by the "Notify Panel
Of" option.
(Note, if the "Cell Fault Time" and "IP Fault Time" options are set to zero, faults will not be
reported.)
 Fault output: Terminal 11 can serve as a fail-safe trigger for communicator fault conditions.
If used, the fault relay will trip when the following conditions occur: tamper*, power loss*, low
battery*, battery charger fault*, loss of network connectivity*, the device is not registered and
the device is remotely disabled by AlarmNet.
*
Alarm reporting for the noted condition must be enabled for it to trigger the fault relay.
 Primary power loss and low battery conditions ("Pwr Loss Rpt," "Low Bat Rpt" options).
 Cover tamper condition ("Tamper Rpt" option).

Antennas

The communicator comes equipped with two internal antennas. This feature provides additional
security to the installation by making the device tamper resistant.
UL / ULC
External antenna has not been evaluated by UL.
4