Honeywell IntelliPath Series Installation And Setup Manual page 46

LTE-I Installation and Setup Guide
[E]
[F]
Operating with 3G service (Applies to LTE-IA ONLY)
RAT RSCP EC/No
3G -xxx -xxxxxx
RSCP MIN MAX
xxxx xxxx xxxx
Cntry Netw LAC
xxx xxx xxxxx
Cell Chan PSC
xxxxxx xxxx xxx
Second Site RSSI
Available
Testing Gateway
Redir 1
Signal Display for 3G
RAT – Radio Access Technology.
RSCP –Received Signal Code Power
Ec/N0 – Carrier Noise Ratio (CNR)
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Min/Max Signal Display for LTE
RSRP – Current Reference Signal Received Power
MIN – Minimum Receive Signal Level
MAX – Maximum Receive Signal Level
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Location Display for 3G
Cntry – Country Code
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cell Display for 3G
Cell – Global Cell ID
Chan – Control Channel in use
PSC – Primary Sync Code
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
3G Status Display Screen 5
Secondary Site RSSI availability. Available or Not Available
will be displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.
Diagnostic
Run Network
Performs a set of network diagnostics that tests the integrity of
the links between the communicator and the various
connection points (Redirs) to AlarmNet. Refer to Section 6:
Network Diagnostics.
42
Test